HP M5035 HP LaserJet M5025 and M5035 MFP Series - Firmware Version 48.015.9 En - Page 2

Fixes or improvements The following fixes or improvements are provided by this firmware release: (Datecode: 20061210 48.015.9) Base Product: ¾ MFP loses contact with NTP if IP address changes ¾ Printing all Private Jobs may not print requested number of copies in each job. ¾ MFP may become unresponsive if the Reset key is pressed during a scan initiated by an MFP-based third party application ¾ Some ADF jams may hang third party SCAPE solutions. ¾ Secure Storage Erase operations may not consistently show up in the event log. ¾ User may not be able to set a paper tray to a standard size after setting it to a custom size ¾ Not able to configure paper trays with the EWS ¾ Incorrect display when setting custom paper size ¾ Flatbed Cover Open warning screen does not clear when cover closed ¾ Changing the Inactivity Timeout may not take effect ¾ Device hangs when cancelling a copy job from the manual feed tray with no size specified ¾ Minor defects in Korean fonts ¾ Scaling percentage is wrong when copying to custom paper size that is smaller than original ¾ Localization errors in some control panel messages ¾ 30.1.38 error code is missing with the error message in all non-English languages ¾ Advanced button missing next to the 'Kerberos Default Realm (Domain)' entry. Clicking the new button brings up a screen with up to 8 alternate Kerberos domain entries. (Note: Not applicable to all models of the M5025) ¾ ¾ Scan "Scaling Error" message is cropped in all languages except English. ¾ Unable to use simple or simple over SSL for LDAP addressing when using Kerberos authentication. (Note: Not applicable to all models of the M5025) ¾ SMTP Authentication may fail when using a Microsoft SMTP Server. ¾ When setting up Embedded Send To Network Folder with MFP User Credentials, the user is prompted to enter Public Credential Information before leaving EWS. (Note: Not applicable to all models of the M5025) ¾ Kerberos Authentication may not work when the LDAP Server Bind Method is anything but Kerberos. (Note: Not applicable to all models of the M5025) ¾ 49.4C02 error may occur after performing restore factory setting following a Disk INIT/NVRAM INIT. Page 2 of 4