HP MDS600 HP StorageWorks 600 Modular Disk System Maintenance and Service Guid - Page 31
Fan, power down the MDS600 before beginning this procedure. - power cabling for redundancy
![]() |
View all HP MDS600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
8. Disconnect the cable from the display board. To replace the component, reverse the removal procedure. Fan IMPORTANT: Configurations using power cord part number 142263-004, located on the power cord label, require that the power cord be removed before removing a fan. Before removing a fan, do the following: • Verify the status of the fan to be replaced by reviewing rear panel LEDs and buttons (on page 57). • Be sure that your configuration can support your actions. If the proper redundancy is not in place, power down the MDS600 before beginning this procedure. To remove the component: 1. Be sure that the hard drive drawer is closed. Removal and replacement procedures 31
![](/manual_guide/products/hewlettpackard-mds600-hp-storageworks-600-modular-disk-maintenance-service-guide-2f4b913/31.png)
Removal and replacement procedures
31
8.
Disconnect the cable from the display board.
To replace the component, reverse the removal procedure.
Fan
IMPORTANT:
Configurations using power cord part number 142263-004, located on the
power cord label, require that the power cord be removed before removing a fan.
Before removing a fan, do the following:
•
Verify the status of the fan to be replaced by reviewing rear panel LEDs and buttons (on page
57
).
•
Be sure that your configuration can support your actions. If the proper redundancy is not in place,
power down the MDS600 before beginning this procedure.
To remove the component:
1.
Be sure that the hard drive drawer is closed.