HP ML310 HP Factory-Installed Operating Systems Software for Microsoft Windows - Page 10

prompted to reboot the server, click No. After the operating system installation is complete, download digitally signed drivers (http://www.hp.com/support/files). Found New Hardware Wizard The Found New Hardware Wizard might appear during the operating system installation. Click Cancel at the Found New Hardware Wizard. Do not attempt to proceed with the installation of drivers until after the second login when the operating system is fully installed. IMPORTANT: Do not attempt to install the drivers during the operating system installation because the server might automatically reboot before the driver installation has been completed. This action could result in the incorrect installation of a device. To install drivers after the operating system installation is complete: 1. Click Next at the Found New Hardware Wizard window. 2. Select Search for a Suitable Driver for My Device. 3. Select Specify a Location, and clear the Floppy Drive and CD-ROM options. 4. Click Next. 5. Enter the following path in the textbox: C:\HPDRVRS 6. Click OK. 7. Click Next at the Driver Files Search Results screen. 8. Click Finish to complete the Found New Hardware Wizard. The setup process begins. Allow the entire setup process to complete, including any requested restarts, before interrupting this process or powering down the server. After the initial setup is complete, the server can be configured to your individual needs. IMPORTANT: The system might complete the driver installation after the first login. Do not perform any actions on the Manage Your Server screen. If additional drivers are loaded, the system completes the driver installation and automatically reboots. The next time the system presents a login prompt, log in normally and use the new operating system. Automatic configuration Some parts of the setup process are automatically configured, and these screens do not appear. In the future, for information about changing any preconfigured information, refer to the operating system online help. Of the screens that are automatically configured, the following might require later changes: • Licensing mode-The server licensing mode is set to per-device or per-user with a five device or user count. To change the licensing mode to per-server after the initial operating system installation is completed, refer to "Changing licensing mode (Standard Edition only) (on page 13)." If additional licenses were purchased, apply the additional licenses after the initial operating system installation completes. For information about adding licenses, refer to the online help or the operating system documentation. • Administrator password-The administrator password has been intentionally left blank. Set the password immediately after the software installation is complete. Do not change the administrator password during the initial setup when entering the computer name because changing the password at this time can cause the automated installation process to abort. For procedures to change the Installation 10