HP Mini 1023TU HP Mini 1000 Netbook - Maintenance and Service Guide - Page 65
Remove the internal display switch bracket, and module
View all HP Mini 1023TU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
4. Remove the DC jack bracket (2) and the USB board (3) from the base enclosure. If it is necessary to replace the internal display switch module, perform the following steps: 1. Remove the Phillips PM2.0×3.0 screw (1) that secures the internal display switch bracket to the base enclosure. 2. Remove the internal display switch bracket (2) and module (3) from the base enclosure. Reverse this procedure to install the USB board. Component replacement procedures 57
4.
Remove the DC jack bracket
(2)
and the USB board
(3)
from the base enclosure.
If it is necessary to replace the internal display switch module, perform the following steps:
1.
Remove the Phillips PM2.0×3.0 screw
(1)
that secures the internal display switch bracket to the
base enclosure.
2.
Remove the internal display switch bracket
(2)
and module
(3)
from the base enclosure.
Reverse this procedure to install the USB board.
Component replacement procedures
57