HP Mini 1126NR HP Mini 1000 and Compaq Mini 700 - Maintenance and Service Guid - Page 51
to which the solid-state drive cable is attached., Release the LIF connector
![]() |
View all HP Mini 1126NR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
6. Lift the hard drive (4) up and slide it out of the drive bay. Reverse this procedure to install the hard drive. To remove the solid-state drive: 1. Release the ZIF connector (1) to which the SIM card cable is attached. The end of the cable lies across the top of the solid-state drive. 2. Disconnect the SIM card cable (2), and then detach the tape from the top of the solid-state drive. 3. Release the LIF connector (1) to which the solid-state drive cable is attached. 4. Disconnect the solid-state drive cable (2). 5. Remove the two Phillips PM2.0×4.5 screws (3) that secure the drive bracket to the device. Component replacement procedures 43
![](/manual_guide/products/hewlettpackard-1035nr-hp-mini-1000-compaq-mini-700-maintenance-service-guide-d6549de/51.png)
6.
Lift the hard drive
(4)
up and slide it out of the drive bay.
Reverse this procedure to install the hard drive.
To remove the solid-state drive:
1.
Release the ZIF connector
(1)
to which the SIM card cable is attached. The end of the cable lies
across the top of the solid-state drive.
2.
Disconnect the SIM card cable
(2)
, and then detach the tape from the top of the solid-state drive.
3.
Release the LIF connector
(1)
to which the solid-state drive cable is attached.
4.
Disconnect the solid-state drive cable
(2)
.
5.
Remove the two Phillips PM2.0×4.5 screws
(3)
that secure the drive bracket to the device.
Component replacement procedures
43