HP Mini 210-4001xx HP Mini 200 - Maintenance and Service Guide - Page 64
system board are clear of the openings in the base enclosure., Remove the system board
View all HP Mini 210-4001xx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Remove the system board: 1. Remove the two Phillips PM2.0×5.7 screws that secure the system board to the base enclosure. 2. Release the power connector (1) from the clip built into the base enclosure. 3. Flex the right side of the base enclosure (2) until the jacks and ports on the right side of the system board are clear of the openings in the base enclosure. 4. Lift the right side of the system board (3) until it rests at an angle. 56 Chapter 4 Removal and replacement procedures
Remove the system board:
1.
Remove the two Phillips PM2.0×5.7 screws that secure the system board to the base enclosure.
2.
Release the power connector
(1)
from the clip built into the base enclosure.
3.
Flex the right side of the base enclosure
(2)
until the jacks and ports on the right side of the
system board are clear of the openings in the base enclosure.
4.
Lift the right side of the system board
(3)
until it rests at an angle.
56
Chapter 4
Removal and replacement procedures