HP Model 750 hp DDS-DC tape drive user's guide (a1658-90696) - Page 41
Troubleshooting and Removal/Replacement Procedures, Managing Clusters of HP 9000 Com, puters
View all HP Model 750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Troubleshooting and Removal/Replacement Procedures 2. Attach the static-grounding wrist strap by following the instructions on the package that contains the strap. 3. Shut down HP-UX. NOTICE: If you are already at the boot administration level, you do not need to shut down; skip this step and go on to Step 4. If you are running HP-UX under HP VUE, shut down your system by performing the shutdown procedure described in the owner's guide that came with your workstation. If you are running HP-UX without HP VUE, shut down your system by typing the following command: # /etc/shutdown -h RETURN You must have superuser privileges to use the /etc/shutdown command. If you do not have superuser privileges, contact your system administrator. If your workstation is part of a cluster, refer to Managing Clusters of HP 9000 Computers for instructions on shutting down. 4. Power off the workstation, using the power switch on the front of the workstation. CAUTION: Do not power off your workstation without first shutting down HP-UX. Powering off with HP-UX still running could damage the data on the disks associated with your workstation. 5. Remove the drive and check the jumpers, as described in "Removal/Replacement Procedures" at the end of this chapter. 6. Replace the drive. 7. Check the cable connections of your DDS-DC drive. Make sure that the connectors are aligned and seated correctly. 3-5