HP Mopier 320 HP Digital Sender Module - Administrator's Guide - Page 56

Address Book error, 05 The Email subsystem

Get HP Mopier 320 PDF manuals and user guides View all HP Mopier 320 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 56 highlights

Activity Log Messages (continued) 079/05 The Email subsystem failed during initialization. An error occurred while the e- q Make sure the PC has mail subsystem was being enough memory. initialized. q Restart the HP Digital Sender Module software. q If the problem persists, contact your HP-authorized dealer. 080/00 Address Book error reading entry: X An entry was not found in the HP Digital Sender Module database. q Use the Address Book Manager to make sure the database contains the correct addresses. q Go to the Configuration Utility and reinitialize the installed devices. q If the problem persists, contact your HP-authorized dealer. 081/00 Job retry error. Cannot An error occurred while read job information from the retrying a previously disk. uncompleted job. q Make sure there are no disk errors. q Restart the HP Digital Sender Module software. q If the problem persists, contact your HP-authorized dealer. 081/01 Error writing job information to the disk. Cannot write job information to q Make sure there are no the PC hard disk. Incapable of disk errors. retrying the job. q Make sure the disk where the Digital Service Module is installed is not full q Restart the HP Digital Sender Module software. q If the problem persists, contact your HP-authorized dealer. 082/00 Firmware has not been The firmware on the MFP was q Go to the Configuration upgraded on the X printer. not updated when the HP Utility and reinitialize the Digital Sender Module was device upgraded. 54 Chapter 3 - Troubleshooting EN

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
54
Chapter
3 - Troubleshooting
EN
079/05 The Email subsystem
failed during initialization.
An error occurred while the e-
mail subsystem was being
initialized.
●
Make sure the PC has
enough memory.
●
Restart the HP Digital
Sender Module software.
●
If the problem persists,
contact your HP-authorized
dealer.
080/00 Address Book error
reading entry: X
An entry was not found in the
HP Digital Sender Module
database.
●
Use the Address Book
Manager to make sure the
database contains the
correct addresses.
●
Go to the Configuration
Utility and reinitialize the
installed devices.
●
If the problem persists,
contact your HP-authorized
dealer.
081/00 Job retry error. Cannot
read job information from the
disk.
An error occurred while
retrying a previously
uncompleted job.
●
Make sure there are no
disk errors.
●
Restart the HP Digital
Sender Module software.
●
If the problem persists,
contact your HP-authorized
dealer.
081/01 Error writing job
information to the disk.
Cannot write job information to
the PC hard disk. Incapable of
retrying the job.
●
Make sure there are no
disk errors.
●
Make sure the disk where
the Digital Service Module
is installed is not full
●
Restart the HP Digital
Sender Module software.
●
If the problem persists,
contact your HP-authorized
dealer.
082/00 Firmware has not been
upgraded on the X printer.
The firmware on the MFP was
not updated when the HP
Digital Sender Module was
upgraded.
●
Go to the Configuration
Utility and reinitialize the
device
Activity Log Messages (continued)