HP MultiSeat ms6200 Hardware Reference Guide HP Compaq MultiSeat ms6005 Deskto - Page 34
Closing the Expansion Slot Retainer, Installing an Expansion Card
View all HP MultiSeat ms6200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
12. To install a new expansion card, hold the card just above the expansion socket on the system board then move the card toward the rear of the chassis so that the bracket on the card is aligned with the open slot on the rear of the chassis. Press the card straight down into the expansion socket on the system board. Figure 2-15 Installing an Expansion Card NOTE: When installing an expansion card, press firmly on the card so that the whole connector seats properly in the expansion card slot. 13. Rotate the slot cover retention latch back in place to secure the expansion card. Figure 2-16 Closing the Expansion Slot Retainer 14. Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed. 15. Replace the access panel. 26 Chapter 2 MultiSeat ms6005 Desktop Hardware Upgrades