HP NetServer LH 6000 Installing SCO UnixWare on an HP Netserver - Page 5
Troubleshooting - netserver lh 6000r
View all HP NetServer LH 6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
NetServer Controller Package Name E 30,40,45 AHA2910 adsl LC Plus AIC7770 adsa LC II,3 AIC7880 adsl LD Pro AIC7880 adsl LH AIC7855 adsl LH Plus, LH Pro AIC7880 adsl LH II,3 AIC7880 adsl LS AIC7870 adsl LX, LXe, LXr Pro AIC7880 adsl LPr Symbios895 c8xx LH3,LH4, Symbios895 c8xx NetRaid 3Si mega LC 2000 Symbios895 slha & mega LH 3000 Symbios896 slha & mega LH 6000 Symbios896 slha & mega LT 6000r Symbios896 slha & mega NOTE: HP currently does not support ultra SCSI mode on the AIC7880 controllers when they are connected to the HP Storage System 6. Ultra SCSI mode is supported for disks installed in the HP NetServer cabinet. Troubleshooting SCO UnixWare is very specific about the hardware configuration it expects when installing. The following limitations apply: The root hard disk and the install device should both be on the primary SCSI channel. The root hard disk must be SCSI ID 0. The first SCSI tape drive must be SCSI ID 2. The first SCSI CD-ROM drive must be SCSI ID 5. The correct SCSI ID is especially important if you are installing from the tape or CDROM drive. If you have a complicated hardware configuration, install SCO UnixWare using only the minimum system required to install. All additional hardware can be added afterwards.