HP NetServer LP 1000r HP Netserver Mass Storage Upgrade Guide - Page 14
Insulating Sheet, Filler Panel 5 places
View all HP NetServer LP 1000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Chapter 2 Installation 1. Orient the hot-swap mass storage cage, as shown in Figure 2-2. The backplane of the cage faces into the empty expansion bay. The connectors on the cage's backplane are near the edge closest to the CD-ROM drive. CAUTION As you insert the cage, be careful not to damage the insulating sheet covering the cage's backplane and part of one side. Insulating Sheet Insulating Sheet Filler Panel (5 places) Filler Panel (5 places) Figure 2-2. Orient and Insert the Hot-Swap Mass Storage Cage 2. Insert the hot-swap mass storage cage by sliding it carefully into the mass storage expansion bay, as shown in Figure 2-2. NOTE If you are installing a secondary mass storage cage that has a duplex board installed, connect the appropriate SCSI cables now, before the cage is fully installed. This gives you easier access to the SCSI connectors. Refer to the HP NetServer Duplex Kit Installation Guide for instructions. 3. When the cage is correctly positioned, press it firmly into place, so that its flanges are flush with the chassis front. 10