HP NetServer LP 1000r Installation Guide for Compaq 4000/7000 Racks - Page 9
Overview
View all HP NetServer LP 1000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Introduction 2 Overview The steps required to install the NetServer in the rack are summarized below: NOTE This is only a summary; detailed instructions are provided on the following pages. • Measure and mark the appropriate holes on all four rack columns. • Install three rack nuts on each of the two front rack columns. • Insert one rack nut on each of the two rear rack columns. • Attach the rails to the columns. • Slide the NetServer onto the rails. • Secure the NetServer to the two front columns. Terms used in this document are defined in the table below. Term Definition Rack nut Rail Rail mounting flange Rack (rack enclosure) EIA unit Single nut designed to clip behind the rack column and accept a screw through the hole in the column Side bracket which is attached to the rack chassis columns on which the NetServer is mounted Mounting flange located at either end of the rail (see Figure 3-3) The equipment enclosure in which the NetServer will be installed Industry standard measurement (1.75 inches / 44.45 mm), consisting of three vertical mounting holes in a rack column 5