HP NetServer LP 2000r HP Netserver E 60, LC 3, LH 3/3r, and LPr Processor Upgr - Page 46
Processor, Module, Secondary, Processor Position, Primary Processor Module in, Primary Processor
View all HP NetServer LP 2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Chapter 4 Installation in E 60 and LPr Installing Processor Modules To install a processor module, refer to Figure 4-5 and do the following: 1. Slide the blue plastic release levers toward the center of the board. 2. Orient the processor module to the correct processor position. The heat sink faces toward the center of the system board. 3. Slide the processor module into the processor mounting bracket and press it firmly into the slot until it is seated completely. When the processor module is fully seated, the blue plastic release levers snap back in the locked position. Processor Module Release Lever Release Lever Secondary Processor Position Primary Processor Module in Primary Processor Position Figure 4-5. Installing a Processor Module in HP NetServer E 60 and LPr (Shown for Secondary Processor Module) 42