HP NetServer LXr Pro8 Installing IBM OS/2 on an HP Netserver - Page 2

Tip 19) Configuring IDE drives as boot device Tip 20) LPr CD-ROM must be configured as "Non-Listed IDE CD-ROM" Tip 21) NetServer LH 3 Embeded SCSI and Raid Adapter Configuration Tip 22) Installing multiple D5013 NICs Tip 23) "Unable to Access the Hard Drive error" message during OS/2 installation Tip 24) IBM's Recommended Procedure Installing OS/2 with New AIC78XX.ADD Tip 25) Fixpak 40 Required for Memory Dump Functionality Consideration 1: Choose the Booting Controller Consideration 2: Selecting the Boot Drive Capacity Consideration 3: Choosing the Boot Drive ID off Embedded Adaptec SCSI Section 2. Creating the HP Drivers/Utilities diskette Procedure One Procedure Two Section 3. OS/2 CD-ROM Installation Procedures Installing Warp 3.0 or Warp Conn. 3.0 or Warp Server 4.0 Detailed Procedure for Installing Warp 3.0, Warp Conn. & Warp Server 4.0 Installing Warp 4.0 or Warp Server SMP 4.0 Section 4. Installing Hewlett-Packard NIC's Installing OS/2 LAN Services for use with the HP J2973A or J2970A 10BaseT PCI LAN Adapter (CD-ROM) Installing LAPS Separately HP J3171A/D5013A PCI Ethernet Adapters General installation - LAN Server and OS/2 Requester (4.0 or 3.0) Advanced Settings Section 5. On-line Information and Software Sources Before You Begin It is critical to know which disk adapters or disk array adapter is in the system before you start the installation. The following table will help you identify what adapter is implemented or embedded on the system board for each HP NetServer. If you add any additional disk adapter, please note it on this table for planning purposes. NOTE: The IBM OS/2 operating systems are not supported on the HP NetServer E series (E 30, E 40, E 45, E 50, and E 60). Table 1a NetServer LX Number of Channels 2 Driver Path on Drivers Diskette \7800 SCSI Driver Name AIC7870.ADD 2