HP Officejet g85 HP OfficeJet G85 - (English) Quick Setup Poster for Macintosh - Page 1
HP Officejet g85 - All-in-One Printer Manual
View all HP Officejet g85 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HP OfficeJet G85 Quick Setup Poster Macintosh Side 1 of 2 1 Unpack your HP OfficeJet Note: The instructions for this poster ONLY apply to Macintosh operating systems. A high-speed USB cable (12 Mbps) no longer than five meters must be purchased separately. a Remove the tray from the carton. b Remove the print cartridges from the sides of the HP OfficeJet. print cartridges c Rest the box on its side d Verify that you have and pull out your HP these additional key OfficeJet. Remove any components. packaging or tape from the HP OfficeJet. power phone cord power cord USB cable print (must purchase cartridges separately) HP OfficeJet Installation CD 2 Load paper a b c 3 Connect the cable Connect the USB cable from your HP OfficeJet to your Macintosh. 4 Secure the cord Make sure the Automatic Document Feeder cord is securely connected to the unit. Check connection here 5 Connect the power cord 1 3 Connect the power supply and the adapter. 2 6 Connect the phone cord Connect the phone/fax cord to the HP OfficeJet and then to the wall 7 Connect office equipment (optional) This diagram shows a possible configuration for connecting additional office equipment. For each piece of office equipment you are connecting to the HP OfficeJet, remove a plastic tab from the phone/fax connector. If you connect a modem, turn off its fax-receive feature. See your Onscreen Guide for information on tone versus pulse dialing and features such as distinctive ring or voice mail. 8 Turn on your HP OfficeJet 9 Insert black print cartridge a Open the door and raise it up until it clicks into place. The printcartridge carriage will move to the middle of the access area. *C6737-90121* *C6737-90121* C6737-90121 b Raise both latches on the print carriage. c Remove the black print cartridge (thinner one) from its packaging and, being careful to touch only the black plastic, gently remove both the green pull tab and the blue tape covering the nozzles. CAUTION: Do not touch or remove the goldcolored contacts. d Push the black print cartridge firmly e Lower the right print-cartridge down into the slot on the right. As latch down onto the top of the you insert the cartridge, make sure cartridge, and push down until the label is facing you. the latch locks firmly into place. Turn over to continue. http://www.hp.com/go/all-in-one