HP Officejet g95 HP OfficeJet G95 - (English) Quick Setup Poster for Windows - Page 1

HP OfficeJet G95 Quick Setup Poster 1 Unpack your HP OfficeJet This poster provides instructions for setting up an HP a OfficeJet on a network. If you are not setting up your HP OfficeJet on a network, refer to HP OfficeJet G Series: Your Basic Guide for more information. Network Requirements Before you set up your HP OfficeJet, you must have the following: • A working 10Base-T Ethernet network using TCP/IP or IPX/SPX protocols • Network PCs that meet the system requirements for the HP OfficeJet including supported network operating systems • An open port on a 10Base-T network hub or switch • A CAT 5 network cable with RJ-45 connectors With the box upright, remove print cartridges, HP two-sided printing accessory and HP JetDirect Print Server. b Rest the box on its side, and pull out your HP OfficeJet. c Make sure you have the following key items: power adapter installation CD power cord print cartridges parallel cable phone cord HP JetDirect HP JetDirect box HP two-sided printing accessory 2 Connect the HP JetDirect Print Server To install the HP JetDirect Print Server, follow these steps: Computer a. Connect the HP JetDirect Print Server to the network using an RJ-45 network cable. b. Connect the HP OfficeJet to the HP JetDirect Print Server using the supplied parallel cable. c. Plug the power supply into the HP JetDirect Print Server, and c then into a power outlet. Network hub or switch a HP JetDirect Print Server b HP OfficeJet Back View of HP JetDirect 10 Test Parallel Input 9-35 VDC J3256 B RJ-45 Network Cable Parallel Cable Power Advanced Users Only: For advanced information, such as setting up on a Novell network or NT server, see the documentation that is packaged with your HP JetDirect Print Server. 3 Attach HP two-sided printing accessory a Turn the knob on the unit's rear access door counterclockwise and remove the door. b Insert the HP two-sided printing accessory into the back of the HP OfficeJet. Make sure it snaps in place. 4 Connect the power cord a 1 3 Connect the power supply and the adapter. 2 b Make sure the Automatic Document Feeder cord is securely connected to the unit. c Connect the phone/fax cord to the HP OfficeJet and then to the wall jack. Check connection here 5 Connect office equipment (optional) This diagram shows a possible configuration for connecting additional office equipment. For each piece of office equipment you are connecting to the HP OfficeJet, remove a plastic tab from the phone/fax connector. If you connect a PC modem, turn off its fax-receive feature. See your Onscreen Guide for information on tone versus pulse dialing and features such as distinctive ring or voice mail. 6 Turn on your HP OfficeJet 7 Load paper ac b c 8 Insert black print cartridge a Open the door and raise it up until it clicks into place. The print-cartridge carriage moves to the middle of the access area. b Raise both latches on the print carriage. c Remove the black print cartridge (thinner one) from its packaging and, being careful to touch only the black plastic, gently remove both the green pull tab and the blue tape covering the nozzles. CAUTION: Do not touch or remove the goldcolored contacts. d Push the black print cartridge firmly down into the slot on the right. As you insert the cartridge, make sure the label is facing you. e Lower the right print-cartridge latch down onto the top of the cartridge, and push down until the latch locks firmly into place. http://www.hp.com/go/all-in-one Turn page over for additional setup.