HP OmniBook 2100 HP OmniBook - DiagTools User's Guide - Page 22
Overview of the Basic System Test, How to Run the Basic System Test
UPC - 873662008284
View all HP OmniBook 2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Basic System Test Overview of the Basic System Test Overview of the Basic System Test The basic system test is performed after hardware detection. The purpose of the basic system tests is to verify the correct operation of the PC's hardware. For each detected hardware component, the test will confirm that: • The component is powered-on • The component has been initialized for use • The component is operating correctly under MS-DOS Unlike the advanced system tests, the basic system test is done automatically and no user input or guidance is needed. This test phase is suitable for all types of users, including novice and non-technical users. Most of the PC's components are tested during the basic system test. To test all of the PC's components, use the advanced systems tests. How to Run the Basic System Test The basic system test is performed after the hardware detection phase. To do the basic system test, follow these steps: 1. Start DiagTools. To learn how to do this, refer to chapter 1, "Starting DiagTools." 2. Follow the instructions on the screen to proceed with hardware detection. Hardware detection is described in chapter 2. 3. You will then be invited to proceed with the basic system test. Press F2 twice to do the basic system test. Note The screen may flicker during the basic system test. This is normal. 3-2