HP OmniBook XE2-DB HP OmniBook XE2 - Online User Guide - Page 31

To replace a hard disk drive

Get HP OmniBook XE2-DB - Notebook PC PDF manuals and user guides View all HP OmniBook XE2-DB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

Using the OmniBook Expanding the OmniBook To replace a hard disk drive You'll need a small Phillips screwdriver to complete this procedure. Note 1. From the Start menu, shut down the OmniBook. 2. Unplug the AC adapter, if present, and remove the battery. 3. Turn the unit bottom side up. 4. Use a screwdriver to remove the hard disk drive locking screw. 5. Slide and hold the hard disk drive latch. 6. Slide the hard disk drive toward the edge of the OmniBook, then lift out. 7. Insert the new hard disk drive and the locking screw. 8. Insert the battery. If you are installing a new hard disk drive, you should create a Hibernate partition on the drive before loading any software-see the instructions included with the drive or go to the OmniBook website at www.hp.com/omnibook. Setup Guide 31

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
Using the OmniBook
Expanding the OmniBook
Setup Guide
31
To replace a hard disk drive
You’ll need a small Phillips screwdriver to complete this procedure.
1.
From the Start menu, shut down the OmniBook.
2.
Unplug the AC adapter, if present, and remove the battery.
3.
Turn the unit bottom side up.
4.
Use a screwdriver to remove the hard disk drive locking screw.
5.
Slide and hold the hard disk drive latch.
6.
Slide the hard disk drive toward the edge of the OmniBook, then lift out.
7.
Insert the new hard disk drive and the locking screw.
8.
Insert the battery.
If you are installing a new hard disk drive, you should create a Hibernate partition
on the drive before loading any software—see the instructions included with the
drive or go to the OmniBook website at www.hp.com/omnibook.