HP OmniBook xe3-gf HP Omnibook Notebook PC XE3-GF - Startup Guide - Page 39
Configuring and Expanding Your Computer, Startup Guide
View all HP OmniBook xe3-gf manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Configuring and Expanding Your Computer Installing RAM Modules 3. Turn the computer over, loosen the screws in the RAM expansion cover (the cover retains the screws), and remove the cover. Note 4. Insert the RAM expansion module into the connector at about a 30° angle until it's fully inserted. Then press down at both sides of the module until it latches. 5. Replace the RAM expansion module door. 6. Insert the battery. Windows 98 only: if you increase your computer's memory to more than 512 MB, the computer will not be able to hibernate unless you also increase the size of the hibernate partition on the hard disk-see "To recover the factory installation of your hard disk" on page 60. To remove the RAM module, release the two latches at the sides of the module. You can also replace the system RAM module beneath the keyboard-see "Error! Reference source not found." in the online Reference Guide. Startup Guide 39