HP P2000 HP StorageWorks P2000 G3 Modular Smart Array Controller Module Replac - Page 3
Transporting CompactFlash (single-controller configurations only), Installing the new module - user guide
View all HP P2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
5. Turn the thumbscrews until the screws disengage from the module (1) and rotate both latches downward to disengage the module from the internal connector (2). 6. Pull the module straight out of the enclosure (3). 3. Carefully remove the CompactFlash from the new controller and set it aside. 4. Insert the CompactFlash that you removed from the failed controller and labeled "Data" into the new controller. NOTE: For clarity, only relevant details are shown in this illustration. Port and LED information is not included. Transporting CompactFlash nl (single-controller configurations only) CAUTION: CompactFlash must be moved from the failed controller to the new controller. If the CompactFlash is not moved to the new controller, data loss or corruption is likely to occur. Installing the new module 1. With the latches in the open position, slide the module into the enclosure as far as it will go (1). If necessary, press lightly on the top-center of the module to facilitate insertion. 2. Rotate the latches upward to engage the module with the internal connector (2) and then, turn the thumbscrews finger-tight (3). 1. If the controller has failed or does not start, make sure that transporting the cache is the appropriate action to take as specified in the user guide. 2. Carefully remove the CompactFlash from the controller, label it "Data," and set it aside. NOTE: For clarity, only relevant details are shown in this illustration. Port and LED information is not included. Page 3