HP P6000 HP Controller Enclosure Fan Module Replacement Instructions (593092-0 - Page 2

Verifying component failure Use the following methods to verify component failure: • Analyze any failure messages received. HP Insight Remote Support Software provides a recommended fault monitoring solution. • Check the fan status using HP P6000 Command View: 1. In the Navigation pane, select Storage system > Hardware > Controller Enclosure. 2. In the Controller Enclosure Properties pane, select the Cooling tab. An Operational state of (Failed) for Fan 1 or Fan 2 would indicate a fault that may require a replacement. 3. To help identify the correct enclosure, click the General tab, and then select Locate > Locate ON. This causes the blue UID indicator to blink on the controller enclosure. • Check the fan module status LEDs: • Solid green (left LED)-Indicates normal fan operation and a replacement is not necessary. • Solid amber (right LED)-Indicates a fault condition and a replacement may be necessary. • Off-Indicates the fan module is not fully connected. Reseating the module may correct the condition, or a replacement may be necessary. 3. Reattach the enclosure front bezel by pressing it into place. Verifying proper operation After replacing the fan module, check the following to verify the component is operating properly: NOTE: Wait approximately 30 seconds for the system to check the component status. • Verify the green LED is lit continuously or blinking. If not, try reseating the fan module. • From HP P6000 Command View, navigate to the component as described in the Verifying component failure section, and check the status. It should be (Good). Removing a fan module 1. Remove the enclosure front bezel by grasping both ends and pulling it off the enclosure. 2. Verify the correct fan module to be replaced. 3. Grasp the handle on the fan module and pull it out a short distance. 4. Position one hand under the fan, and with the other hand, pull the fan out of the enclosure. Figure 2 Removing a fan module . Installing a fan module 1. Insert the fan module into the enclosure opening. 2. Push the fan module into the enclosure until a click is detected when fully seated. Page 2