HP P6300 HP P6000 EVA Release Notes (XCS 11001100) (5697-2516, March 2013) - Page 7
Hardware replaceable parts, device ports, resynchronization, Operating systems, Upgrade - firmware
View all HP P6300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Hardware (replaceable parts, device ports, resynchronization) This section describes issues affecting physical hardware, which can lead to incorrect condition handling, false condition reporting and similar events that may lead to incorrect device status reporting or replacement. • Fixed issue in which some power supply, fan and battery status information was not properly reported when operating in single controller mode. • Fixed an issue where firmware reports an incorrect LUN access state change while mastership of a LUN is still changing from one controller to another. • Fixed an issue where performance metrics reported by the firmware are calculated incorrectly. • Fixed an issue where the disk enclosure power supply threshold was set incorrectly, causing excessive power supply status messages to be logged. • Fixed issue in which some transceivers from the AP712A expansion kit cause I/O module port errors upon installation. • Earlier versions of the controller software did not report fan failures. Starting with XCS 11001000, fan failures are reported. After upgrading your controller software, if you notice fan errors, replace the fans. Operating systems For complete information about operating system specifications and supported configurations, see the Single Point of Connectivity Knowledge (SPOCK) at http://www.hp.com/storage/spock. You must log in to access SPOCK. If you do not already have an account, select Register to log in on the main page and follow the instructions. Windows 2003 and Windows 2008 Clusters running MSCS: HP P63x0/P65x0 storage system's FCoE connectivity configured to utilize the 10-GbE iSCSI/FCoE modules with V3.2.2.8 firmware are not supported. Upgrade and downgrade paths For details about supported upgrade paths to XCS 11001100, see Table 3.1, Upgrade support for controller software versions, in the HP P6000 Enterprise Virtual Array Compatibility Reference. For supported downgrade paths from XCS 11001100, see Table 3.2, Downgrade support for controller software versions in the compatibility reference. For upgrade instructions, see the HP Enterprise Virtual Array Updating Product Software Guide (XCS 11001100). You can download these documents from the following website: http://www.hp.com/support/manuals Under Storage, click Disk Storage Systems, and then under EVA P6000 Storage, select your storage system. HP P6000 SmartStart HP P6000 SmartStart is a disk-based wizard that you use on your Windows Server 2003 or 2008 system to install and configure HP P6000 Command View. You can use HP P6000 Command View to configure, manage, and monitor your storage system. Hardware (replaceable parts, device ports, resynchronization) 7