HP Pavilion 4500 HP Pavilion PCs - (English) Seagate Hard Drive U Series 10 Ma - Page 26
Jumper settings, Master/slave configuration
View all HP Pavilion 4500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
18 U10 Family Product Manual, Rev. A 2.2 Jumper settings 2.2.1 Master/slave configuration The options jumper block shown in Figure 2 is used to configure the drive for operation. It is the 6-pin dual header between the interface connector and the power connector. Use the following settings to configure the drive as a master or a slave. Master or single drive. The drive is configured at the factory for a master or single-drive operation with a jumper set on pins 7 and 8. Drive as slave. Remove all jumpers. Drive as master with a non-ATA-compatible slave. Set a jumper on pins 5 and 6 and a jumper on pins 7 and 8. Use this jumper setting only if the drive does not work as a master with no jumpers installed. Options jumper block (J8) Master or single drive Drive is slave Master with a non-ATAcompatible slave Cable select 7531 8642 Figure 2. Master/slave jumper settings