HP Pavilion 570-p000 Graphics Card Replacement Instructions - Page 1
HP Pavilion 570-p000 Manual
View all HP Pavilion 570-p000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Graphics Card Replacement Instructions 936167-001 Before you begin Observe the following requirements before removing and replacing graphics cards. WARNING: To reduce the risk of serious injury or damage to the equipment, do not open the chassis cover of any unit with a 750W power supply. To determine if you have a 300W, 500W or 750W power supply, refer to the label on the rear of the computer. CAUTION: Never open the cover with the power cord attached or power applied. You might damage your computer or be injured by the spinning fan blades. Tools needed Phillips #2 screwdriver Small screws are easily lost. Remove screws over a surface that enables you to retrieve them if they fall. NOTE: Computer appearance and features may vary by model. NOTE: When using an add-on, discrete graphics card, you must connect your display to the port on the graphics card. The covered UMA graphics port that is integrated into the computer system board does not function when an add-on graphics card is installed. CAUTION: Avoid touching sharp edges inside the computer. NOTICE: Static electricity can damage the electronic components inside the computer. Discharge static electricity by touching the metal cage of the computer before touching any internal parts or electronic components. NOTE: When using an SLI graphics card configuration, be sure to connect your display to the port in the primary graphics card closest to the processor. Removing a graphics card 1. Press the power button to turn off the computer. 2. Disconnect the power cord and all attached cables from the back of the computer. 936167-001 1