HP Pavilion 570-p000 Optical Drive Replacement Instructions
HP Pavilion 570-p000 Manual
View all HP Pavilion 570-p000 manuals
Add to My Manuals
Save this manual to your list of manuals |
HP Pavilion 570-p000 manual content summary:
- HP Pavilion 570-p000 | Optical Drive Replacement Instructions - Page 1
Optical Drive Replacement Instructions 904514-001 Before you begin Observe the following requirements before removing and replacing the optical drive. WARNING: Never open the cover while the power cord - HP Pavilion 570-p000 | Optical Drive Replacement Instructions - Page 2
3. Locate the optical drive: 1. Hard drive 2. Optical drive 3. Memory modules 4. Disconnect the data and power cables from the rear of the drive (1), and then push the green release latch toward the center of the drive (2). 5. Pull the drive out through the front bezel. 6. Remove the latch by - HP Pavilion 570-p000 | Optical Drive Replacement Instructions - Page 3
Replacing the optical drive 1. You must attach the release latch before installing the new optical drive. Carefully align the holes on the release latch with the pins on the side of the optical drive. Press the entire release latch firmly to fasten the latch securely to the optical drive. 2. Slide - HP Pavilion 570-p000 | Optical Drive Replacement Instructions - Page 4
button to turn on the computer. back of the computer. © Copyright 2016 HP Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and
904514-001
1
Optical Drive Replacement Instructions
Before you begin
Observe the following requirements before removing and
replacing the optical drive.
WARNING
: Never open the cover while the power cord
is attached. You might damage your computer or be
injured by the spinning fan blades.
WARNING
: Avoid touching sharp edges inside the
computer.
CAUTION
: Static electricity can damage the electronic
components inside the computer. Discharge static
electricity by touching the metal cage of the computer
before touching any internal parts or electronic
components.
Tools needed
Phillips #2 screwdriver
Removing the optical drive
1.
Disconnect the power cord and all attached cables from
the back of the computer.
2.
To remove the access panel, loosen the captive Phillips
screw
(1)
, slide the access panel back, and the lift it off
the computer
(2)
.
904514-001