HP Pavilion a300 HP Pavilion Desktop PCs - (English) Warranty and Support Guid - Page 9

Regulatory and Safety Information WARNING: The HP Pavilion is heavy; be sure to use ergonomically correct lifting procedures when moving the computer. WARNING: Electrostatic discharge (ESD) can damage disk drives, add-in cards, and other components. If an ESD station is not available, wear a wrist strap attached to a metal part of the computer. Place cards on a conductive foam pad or inside the conductive wrapper they came in; do not place the cards on top of the wrapper. WARNING: Do not operate the system with the cover removed. Always replace the cover before turning on the system. WARNING: Please read the "Additional Safety Information" located later in this document before installing and connecting your system to the electrical power system. WARNING: Using the wrong type of memory module could damage the system. WARNING: Do not pull the memory module out of the socket. Use the retaining clips to eject the module. WARNING: Do not overload the system by installing add-in cards that draw excessive current. The system is designed to provide 2 amps (average) of +5 V power for each board/card in the computer. The total +5 V current draw in a fully loaded system (one with all add-in card slots filled) must not exceed the total number of slots multiplied by 2 amps. WARNING: Be careful of the sharp edges on the expansion slot cover. WARNING: There is danger of an explosion if the battery is incorrectly replaced. Replace only with the same, or equivalent, type of battery. Discard used batteries according to the manufacturer's instructions. ENERGY STAR Compliance Hewlett-Packard Pavilion PCs and Monitors marked with the ENERGY STAR® logo on the packaging box qualify with the U.S. Environmental Protection Agency's ENERGY STAR guidelines for energy efficiency. Products with the ENERGY STAR label are designed to use less energy, help you save money on utility bills, and help protect the environment. ENERGY STAR® is a registered trademark owned by the U.S. government. Australia Telecom Statement The computer must be connected to the Telecommunication Network through a line cord that meets the requirements of ACA Technical Standard TS008. WARNING: Modems without integral RJ-11 that are shipped with this computer must be installed only in devices displaying the A-tick. New Zealand Telecom Statement The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work correctly in all respects with another item of Telepermitted equipment of a different make or model, nor does it imply that any product is compatible with all of Telecom's network services. Some parameters required for compliance with Telecom's Telepermit requirements are dependent on the equipment (PC) associated with this modem. The associated equipment shall be set to operate within the following limits for compliance with Telecom's specification: • For automatically initiated calls to the same number: • There shall be no more than 10 call attempts to the same number within any 30-minute period for a single manual call initiation. And • The equipment shall be on the hook for a period of not less than 30 seconds between the end of one attempt and the beginning of the next attempt. 9