HP Presario CQ60-100 Compaq Presario CQ60 Notebook PC and HP G60 Notebook PC - - Page 50
from each side of the hard drive., If it is necessary to replace the hard drive bracket
View all HP Presario CQ60-100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
3. Remove the three Phillips PM2.5×5.0 screws 1 that secure the hard drive to the computer. 4. Grasp the Mylar tab 2 on the hard drive, and then slide the hard drive 3 to the right to disconnect it from the system board. 5. Remove the hard drive 4 from the hard drive bay. 6. If it is necessary to replace the hard drive bracket, remove the two Phillips PM3.0×4.0 hard drive bracket screws 1 from each side of the hard drive. 7. Lift the bracket 2 straight up to remove it from the hard drive. Reverse this procedure to reassemble and install the hard drive. Removal and replacement procedures 4-11
Removal and replacement procedures
4–11
3. Remove the three Phillips PM2.5×5.0 screws
1
that secure the hard drive to the computer.
4. Grasp the Mylar tab
2
on the hard drive, and then slide the hard drive
3
to the right to disconnect it from the
system board.
5. Remove the hard drive
4
from the hard drive bay.
6. If it is necessary to replace the hard drive bracket, remove the two Phillips PM3.0×4.0 hard drive bracket
screws
1
from each side of the hard drive.
7. Lift the bracket
2
straight up to remove it from the hard drive.
Reverse this procedure to reassemble and install the hard drive.