HP Presario CQ61-300 Compaq Presario CQ61 Notebook PC and HP G61 Notebook PC - - Page 80
of the system board., Grasp the right edge
View all HP Presario CQ61-300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Removal and replacement procedures Remove the system board: 1. Disconnect the USB board cable 1 from its mounting clip in the base enclosure. 2. Disconnect the Bluetooth cable 2 from the system board. 3. Disconnect the RJ-11 cable 3 from the system board. 4. Disconnect the power connector cable 4 from the system board. 5. Remove the Phillips PM2.5×6.0 screw that secures the system board to the base enclosure. 6. Grasp the right edge 1 of the system board. 7. Lift the system board 2, and pull it away from the base enclosure 3 at an angle. Reverse this procedure to install the system board. Maintenance and Service Guide 4-37
Removal and replacement procedures
Maintenance and Service Guide
4–37
Remove the system board:
1. Disconnect the USB board cable
1
from its mounting clip in the base enclosure.
2. Disconnect the Bluetooth cable
2
from the system board.
3. Disconnect the RJ-11 cable
3
from the system board.
4. Disconnect the power connector cable
4
from the system board.
5. Remove the Phillips PM2.5×6.0 screw that secures the system board to the base enclosure.
6. Grasp the right edge
1
of the system board.
7. Lift the system board
2
, and pull it away from the base enclosure
3
at an angle.
Reverse this procedure to install the system board.