HP Presario SR2100 Upgrading and Servicing Guide - Page 6
After Closing the PC, Removing the Side Panel, This procedure is necessary only when removing or
View all HP Presario SR2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
After Closing the PC To avoid injury and equipment damage, always follow this procedure in this order after closing the PC. 1 Reconnect the power cord. Replacing the Side Panel 1 Place the side panel in the proper position on the chassis and slide it into place. WARNING: To reduce the risk of electrical shock, fire, or damage to the equipment, do not plug telecommunications or telephone connectors into the network interface card (NIC) (labeled as an Ethernet connector). 2 Reconnect the modem/telephone cable, and all other cables (such as the keyboard, mouse, and monitor) and external devices. 3 Turn on the PC and all peripherals. 4 If you installed an add-in card, install any software drivers supplied by the card manufacturer. Removing the Side Panel 1 Remove the side panel by loosening the screw (D) that secures the panel to the PC chassis. 2 Ensure that the hole for the thumbscrew aligns with the hole in the chassis, and replace the thumbscrew (D). Removing the Front Panel This procedure is necessary only when removing or replacing an optical drive, memory card reader, diskette drive, or the hard disk drive. 1 Press the three tabs toward the center of the chassis (1). 2 Slide the panel back about 1 inch (2.5 cm), and then lift it off the unit. WARNING: Beware of sharp edges inside the chassis. 2 Swing the front panel away from the chassis toward the right. 3 Lift the front panel up slightly and remove it. 2 Upgrading and Servicing Guide