HP Pro 2080 Safety and Regulatory Information Desktops, Thin Clients, and Pers - Page 10
Compliance with International Regulations, Laser Product Label, Laser Information
View all HP Pro 2080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Compliance with International Regulations All systems equipped with CD-ROM drives comply with appropriate safety standards including IEC 825. Laser Product Label The following label or equivalent is located on the surface of laser products: This label indicates that the product is classified as a CLASS 1 LASER PRODUCT. This label appears on a laser device installed in the product. If you have an LS-120 drive or an LS-260 drive, this label is located next to the Class 1 Laser Product label on the system. Laser Information ● Laser Type: Semiconductor GaAIAs ● Wave Length: 780 +/- 35 nm ● Divergence Angle: 53.5 Degrees +/- 0.5 degrees ● Output Power: Less than 0.2 mW or 10,869 W·m-2 sr-1 ● Polarization: Circular 0.25 ● Numerical Aperture: 0.45 +/- 0.04 Power Supply and Power Cord Set Requirements Power Supply Class I Grounding Requirements For protection from fault currents, the equipment shall be connected to a grounding terminal. Plug the system power cord into an AC outlet that provides a grounded outlet. Substitute cords may not provide adequate fault protection. Only use the power cord supplied with this product or a Hewlett-Packard authorized replacement. Denmark For tilslutning af de øvrige ledere, se medfølgende installationsvejledning. Norway Apparatet må kun tilkoples jordet stikkontakt. 4 Chapter 1 Safety Notices ENWW