HP Pro All-in-One MS219la Maintenance and Service Guide: HP Pro All-in-One ms2 - Page 28
Fan, Remove the stand see
View all HP Pro All-in-One MS219la manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
5. Remove the back cover (see Back cover on page 18). 6. Remove the system board shield (see System board shield on page 19). 7. Remove the antenna cables (1) from the module. 8. Remove the screw (2) that secures the module to the system board. NOTE: Some modules may be secured by two screws. 9. Lift the module out of the slot at an angle. NOTE: The WLAN module has a notch to prevent incorrect installation. To install the WLAN module, reverse the removal procedures. Fan 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 5). 2. Remove the stand (see Stand on page 11). 3. Remove the hard drive (see Hard drive on page 13). 4. Remove the optical drive (see Optical drive on page 16). 5. Remove the back cover (see Back cover on page 18). 6. Remove the system board shield (see System board shield on page 19). 7. Remove the four screws (1) that secure the fan to the system board, and then lift the fan partially out of the computer. 22 Chapter 3 Removal and Replacement Procedures