HP ProLiant 4500 Compaq ProLiant 4500R Rack-Mountable Servers Maintenance and - Page 42
Run the System
View all HP ProLiant 4500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
3-10 Diagnostic Tools POST Error Messages Continued Error Code Beeps Probable Source of Problem Action *1788-Incorrect Drive Replaced: Drive X Drive(s) were incorrectly replaced: Drive Y Select "F1" to continue - drive array will remain disabled. Select "F2" to reset configuration - all data will be lost. None Drives are not installed in their original positions, so the drives have been disabled. See note below. Reinstall the drives correctly as indicated. Press F1 to restart the computer with the drive array disabled. -OrPress F2 to use the drives as configured and lose all the data on them. *NOTE: The 1788 error message might also be displayed inadvertently due to a bad power cable connection to the drive or by noise on the data cable. If this message was due to a bad power cable connection, but not due to an incorrect drive replacement, repair the connection and press F2. -OrIf this message was not due to a bad power cable connection, and no drive replacement took place, this could indicate noise on the data cable. Check cable for proper routing. 1789-Drive Not Responding, Physical Drive Check cables or replace physical drive X. Select "F1" to continue - drive array will remain disabled. Select "F2" to fail drive(s) that are not responding Interim Recovery Mode will be enabled if configured for fault tolerance. None Cable or hard drive failure. 1. Check the cable connections. 2. If cables are connected, replace the drive. 3. If you do not want to replace the drives now, press F2. 1790-Disk 0 Error None Hard drive error or wrong drive type. Run the System Configuration Utility and Diagnostics and correct. 1791-Disk 1 Error None Hard drive error or wrong drive type. Run the System Configuration Utility and Diagnostics and correct. Continued Maintenance and Service Guide