HP ProLiant BL25p HP Power Capping and Dynamic Power Capping for ProLiant serv - Page 24
Subtleties of power capping - server manual
View all HP ProLiant BL25p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Subtleties of power capping Avoiding power capping conflicts within groups IPM is a powerful tool for setting and managing power caps across defined groups of servers, including SIM collections. It is important to remember, however, that except for Enclosure Dynamic Power Capping, power caps are ultimately set at the individual server level. A group power cap set through IPM is simply apportioned as individual power caps to all of the servers in the group. Power capping is also completely non-hierarchical. A power cap set using IPM has no precedence over a power cap set using the iLO interface. Each server simply conforms to the last power cap that it received, regardless of the method by which it was set. For example, consider a server that is a member of two distinct SIM collections. If a group power cap is applied to each of these collections, servers that are in both collections will have individual power caps that reflect the later collection to have a power cap applied. Similarly, if the iLO interface is used to set a power cap on an individual server, it will replace the previous power cap for that server, even if it was part of a group with its power cap set through Insight Power Manager. Since Insight Manager sees a group power cap as a simple aggregation of individual power caps, changing the power cap of an individual server will eventually be reflected in the number displayed for a group power cap in Insight Power Manager. A similar situation can occur when setting enclosure dynamic power caps for groups of enclosures using IPM. Once a group power cap has been apportioned to the individual enclosures, those individual enclosure caps can be overwritten by setting a new cap on a single enclosure through its Onboard Administrator. This potential overlap in setting power caps is important to take into account when planning and implementing an overall power capping/capacity management strategy. Conflicts can best be avoided by choosing a single consistent method for setting power caps. For example, a system administrator could define a set of non-overlapping SIM collections used specifically for power and cooling management. Powering-up groups of servers when using Dynamic Power Capping HP Dynamic Power Capping is a powerful tool for controlling the steady-state power consumption of servers in real time. However, it does not control the power consumption of servers at start-up. If a group of servers on the same PDU are powered up simultaneously, there will be a window during start-up before Dynamic Power Capping is online when the servers determine their maximum power consumption and will draw close to their maximum power at roughly the same time. If this peak is too large, it may cause problems. To prevent this from occurring, it is important to manually power on these server groups in a staggered manner. In the case of auto power-up situations, this staggered power-up can be achieved by enabling the servers' Power On Delay and setting it to ―Random up to 120 seconds.‖ This is accomplished through the iLO interface or through the enclosure OA for BladeSystem servers. Setting low or unattainable power caps on servers In theory, a power cap can be set to any value that is above the minimum power consumption for a given server or a group of servers. However, setting power cap values close to the minimum power consumption is not good practice since maintaining a power cap at or near this level prevents the server from accomplishing meaningful work. Additionally, a server's minimum power consumption level may rise over time due to a number of causes, including increases in fan activity as data center temperatures rise or the hot-add of disk drives to the server. This can result in a situation where a power cap becomes unachievable since it has become lower than the minimum power consumption 24