HP ProLiant DL388p Configuring Arrays on HP Smart Array Controllers Reference - Page 55
Spare Activation Mode: Activate on drive failure, Total Cache Memory Available: 816 MB
View all HP ProLiant DL388p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
When you specify a target that consists of several devices, the information in the output is normally less comprehensive than when you specify only one device as the target. You can use the [detail] parameter in this case to retain all the information usually given for individual devices. An extra parameter is available for controller targets: config. This parameter is used as follows: show config [detail] If you use the config parameter, the output includes information about each device connected to the controller. Example 1 => ctrl slot=9 show A typical output would be: Smart Array P421 in Slot 9 Bus Interface: PCI Slot: 9 Serial Number: PBKTV0XTAZZ005 RAID 6 (ADG) Status: Enabled Controller Status: OK Hardware Revision: A Firmware Version: 0.02-106 Rebuild Priority: Medium Expand Priority: Medium Surface Scan Delay: 3 secs Surface Scan Mode: Idle Queue Depth: Automatic Monitor and Performance Delay: 60 min Elevator Sort: Enabled Degraded Performance Optimization: Disabled Inconsistency Repair Policy: Disabled Wait for Cache Room: Disabled Surface Analysis Inconsistency Notification: Disabled Post Prompt Timeout: 15 secs Cache Board Present: True Cache Status: OK Accelerator Ratio: 10% Read / 90% Write Drive Write Cache: Disabled Total Cache Size: 1024 MB Total Cache Memory Available: 816 MB No-Battery Write Cache: Disabled Cache Backup Power Source: Capacitors Battery/Capacitor Count: 1 Battery/Capacitor Status: OK SATA NCQ Supported: True Spare Activation Mode: Activate on drive failure Controller Temperature (C): 40 HP Array Configuration Utility 55