HP ProLiant SL165z HP ProLiant SL165z G6 Server Installation Sheet - Page 1

HP ProLiant SL165z G6 Server Installation Sheet Part number: 577857-001 September 2009 (First edition) Identifying Server Components Front Panel Components Figure 1 Front panel components of the chassis with 2 SL165z servers Item Description 1a Handle 1b latch 2 PS/2 mouse port (green) 3 Two USB 2.0 ports 4 IPMI Port 5 Serial Port 6 UID 7 PCIe Slot 8 Health LED 9 Power Button 10 Video Port 11 Top: NIC Connector Bottom: NIC Connector 12 PS/2 keyboard port (purple) Rear Panel Components Figure 2 Rear panel components of the chassis Item Description 1 Power supply 2 2 Power supply 1 3 UID LED Server configuration resources In addition to this Installation Sheet, other resources are available for more information regarding the configuration and maintenance of your server: • For safety information and detailed procedures relating to installation of options, refer to any installation instructions that came with the option, as well as the HP ProLiant SL165z G6 Server Maintenance and Service Guide. • For safety information and detailed procedures related to the rest of the steps listed in the "Configuring the Server" section, refer to relevant chapter of the HP ProLiant SL1000/6000 Series Server User Guide. • For information relating to system BIOS configuration and operating system installation, refer to relevant section of the HP ProLiant SL165z G6 Server Software Configuration Guide. • You can also access additional information and documentation from the HP website at http://www.hp.com/. Server Configuration Overview The steps listed below give an overview of the necessary setup procedures for preparing the HP ProLiant SL165z G6 Server for operation: 1. Connect the AC power cord and peripheral devices. 2. Power up the server. 3. Press "F10" to enter BIOS setup. 4. Note the server BIOS version. 5. Verify the server BIOS version against the latest BIOS version listed for this server. 6. If you do not have the latest BIOS, update the BIOS now. Refer to the HP ProLiant SL165z G6 Server Maintenance and Service Guide available on the HP website: http://www.hp.com. Pre- and post-installation procedures When installing additional options in your HP ProLiant SL165z G6 server, observe the following procedures: Pre-installation procedures 1. Turn off the server and all the peripherals connected to it. 2. Remove the server from the chassis by following the procedures described later in the "Removing the server" section. Post-installation procedures 1. Be sure all components are installed according to the described step-by-step instructions. 2. Check to make sure you have not left loose tools or parts inside the server. 3. Reinstall the PCI riser, peripherals, and system cables that you have removed. 4. Reinstall the server into the chassis. 5. Connect all external cables to the system. 6. Press the power button on the front panel to turn on the server. Removing the server You need to remove the server from the chassis before you can remove or replace a server component. CAUTION: When the servers are operational, tray blank 577723-001(Option Kit P/N 579069-B21) must be installed in the server slot after removal of the server. To remove the server: 1. Press the tray latch to release the tray handle. 2. Rotate the tray handle to disengage the power connector. 3. Pull the server tray assembly out of the chassis. 4. Install the tray blank in the server slot. Figure 3 Removing the server