HP Rp7410 HP DLPI Programmer's Guide - Page 82
Dl_enabmulti_req
![]() |
View all HP Rp7410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
DLPI Primitives Local Management Primitives Primitive was issued from an invalid state. DL_SYSERR A system error has occurred and the UNIX system error is indicated in the DL_ERROR_ACK. The UNIX error returned may be set to (not limited to) errors listed in Table 2-2 on page 71. DL_BADADDR The DLSAP address information was invalid or was in an incorrect format. DL_ENABMULTI_REQ Requests the DLS Provider to enable specific multicast addresses on a per Stream basis. It is invalid for a DLS Provider to pass upstream messages that are destined for any address other than those explicitly enabled on that Stream by the DLS User. Format The message consists of one M_PROTO message block, which contains the following structure: typedef struct { ulong dl_primitive; ulong dl_addr_length; ulong dl_addr_offset; } dl_enabmulti_req_t; Parameters dl_primitive DL_ENABMULTI_REQ dl_addr_length length of the multicast address. dl_addr_offset offset from the beginning of the M_PROTO message block where the multicast address begins. State 82 Chapter 2
![](/manual_guide/products/hewlettpackard-rp5405-hp-dlpi-programmers-guide-0ec5ab3/82.png)