HP S9500 Reference Guide - CRT Monitors 5500, v72, mx704, 7500, 7550, 9500 - - Page 19
Troubleshooting, Reference Guide
View all HP S9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Troubleshooting Problem Possible Cause Solution "No Signal" is displayed on screen. Monitor video cable is disconnected. Connect the 15-pin monitor video cable to the computer. Be sure that the computer power is on. "Out of Frequency" is displayed on screen. Video resolution and/or refresh Restart your computer rate are set higher than what and enter Safe Mode. your monitor supports. Change your settings to a supported setting (see "Technical Specifications"). Restart your computer so that the new settings take effect. Monitor is overheating. There is not enough air space to Leave at least 3 inches allow proper ventilation. (76 mm) of ventilation space around the monitor, and do not place objects on top of the monitor. Reference Guide A-3
Troubleshooting
Problem
Possible Cause
Solution
“No Signal” is
displayed on screen.
Monitor video cable is
disconnected.
Connect the 15-pin
monitor video cable to
the computer. Be sure
that the computer power
is on.
“Out of Frequency” is
displayed on screen.
Video resolution and/or refresh
rate are set higher than what
your monitor supports.
Restart your computer
and enter Safe Mode.
Change your settings to
a supported setting (see
“Technical
Specifications”). Restart
your computer so that
the new settings take
effect.
Monitor is overheating.
There is not enough air space to
allow proper ventilation.
Leave at least 3 inches
(76 mm) of ventilation
space around the
monitor, and do not
place objects on top of
the monitor.
Reference Guide
A-3