HP SN6000B HP Network Advisor B-series Enterprise, Professional Plus, and Prof - Page 20

FC port type value for imported HBAs Brocade_topologyview.AntecedentFCPortType property value corresponding to the imported HBA is shown as L_Port. Migration Issue Properties configured in the SMI Agent Configuration Tool do not migrate from DCFM 10.4.0 (Solaris) to DCFM 10.4.0 (Windows) through the Copy Data and Settings screen when migrating from DCFM 10.4.0 (Solaris) to DCFM 10.4.0 (Windows) to Network Advisor 11.1.1 (Windows). Documentation Updates For the most recent Network Advisor documentation, visit the following HP website: http:// h18006.www1.hp.com/products/storageworks/dc_fabricmgr/index.html. Under Support, select HP Support & Documents, and then select Manuals. HP Network Advisor 11.1.0 fixes Table 7 lists the defects that were closed for this release. Table 7 HP Network Advisor 11.1.0 closed defects Closed fixes summary Solution Brocade Access Gateway (AG) switches running Fabric OS 5.3 were not shown in DCFM and an inappropriate message was shown when Fixed in HP Network Advisor 11.1.0. trying to rediscover the fabric. Master log reports port number and port index as one greater than actual value. Fixed in HP Network Advisor 11.1.0. DCFM server runs out of memory when managing HP StorageWorks SAN Director 2/128 or HP StorageWorks 4/256 SAN Director switches for several weeks. Fixed in HP Network Advisor 11.1.0. Server backup fails to authenticate with Network drive after a server reboot. Fixed in HP Network Advisor 11.1.0. The twelfth character of a LUN Serial Number (LSN) is getting dropped on some paths in the Encryption Disk LUN View. Fixed in HP Network Advisor 11.1.0. Master Trunk ports in product tree and connections between AG and a switch are not shown properly when F_Port trunking is enabled on the AG setup. Fixed in HP Network Advisor 11.1.0. Remote VE_Port WWN is shown as missing and with a red icon under end devices. Fixed in HP Network Advisor 11.1.0. Fault Management - "VFID" is shown as "Chassis" for "Switch name change event" in the master log. Fixed in HP Network Advisor 11.1.0. There are yellow dotted lines shown between the segmented switch and the End Device in the re-discovered fabric. Fixed in HP Network Advisor 11.1.0. 20