HP Scitex FB550 Instructions for printing with Roll-to-Roll supply and takeup - Page 3

If the media is ready for loading select the load procedure (there are two options: "Restore Loaded State" or "New Load"): - If the media has already been properly attached to the take-up spool just select "Restore Loaded State", indicate the thickness (in cm or in inches using a caliper) and the length (in cm or in inches). - If it is a new roll load select "New Load" and follow the steps indicated by the media wizard. It will provide you with visual aids throughout the media loading process: Fig. 4. Roll-to-Roll loading procedure sketch. 1. Move the Foam Press Roller to the upper resting position: Fig. 5. First step and sketch of the loading procedure. Tip: Save time turning the UV lamps ON before completing the whole loading procedure. 2. Pull the media from the roll, pull it over the foam lift roller and lay it on the belt to the input media roller (points 2 & 3 in Fig. 4.). 3. Use the belt to pull the media through the printer until it reaches the takeup. LFP/3D Customer Assurance 3 HP Public