HP Scitex LX800 HP Scitex LX Printer Family - Maintenance and troubleshooting - Page 69
Front-panel error messages
View all HP Scitex LX800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
10 Front-panel error messages Occasionally you may see one of the following messages appear on the front-panel display. If so, please follow the advice in the Recommendation column. If you see an error message that does not appear here, and you feel in doubt about the correct response, or if you have followed the recommendation but the problem persists, call your service representative. See HP Customer Care Centers on page 68. Table 10-1 Text messages Message Recommendation {Color} cartridge is altered {Color} cartridge is low on ink {Color} cartridge is missing {Color} cartridge is out of ink {Color} cartridge has expired {Color} printhead is missing Alignment pending A wrong printhead has been detected An error has occurred in printhead detection Clean drop detector spittoon Cleaner roll jam. Check cleaner roll module. Color calibration cancelled because of scanning errors Disconnected Ink system not ready to print Job canceled due to lack of data received from the IPS Line sensor calib. error: substrate too small Low cleaner roll You are advised to replace the ink cartridge. See the User's guide. Be ready to replace the ink cartridge soon. Install the correct ink cartridge. See the User's guide. Replace the ink cartridge. See the User's guide. You are advised to replace the ink cartridge. See the User's . Install the correct printhead. See the User's guide. You are advised to perform printhead alignment. See Align the printheads on page 7. Check that the correct printheads and the latest firmware release have been installed. Remove the printhead, clean any ink from the electrical connectors on the printhead (do not try to clean the nozzles), and reinsert the printhead. See the User's guide. You are advised to clean the ink deposits. See Clean the ink deposits on page 22. Go to the front panel and select the Ink System menu, then Check cleaner roll. Pull out the printhead cleaning roll assembly, raise the pinchwheels, wind the roll forward manually, then lower the pinchwheels and push the assembly back into the printer. The color calibration chart could not be scanned successfully with the current substrate. See Color calibration fails on page 62. Check the connection to the printer. Please wait a while. If the printer does not recover, restart it. If the problem persists, check the configuration of the HP Internal Print Server computer. Load a larger substrate. Be ready to replace the printhead cleaning roll soon. ENWW 63 Front-panel errors