HP Server tc3100 hp server tc3100 installation sheet (English) - Page 1
HP Server tc3100 Manual
View all HP Server tc3100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
P/N P3501-90005 Printed in November 2001 Printed on recycled paper Copyright 2001, Hewlett-Packard Company. Hewlett-Packard Company Network Server Division Technical Communications 10955 Tantau Avenue Cupertino, California 95014 USA n•šŒ†ˆ The information contained in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this )material,)includin)g, but n)ot limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. Hewlett-Packard assumes no responsibility for the use or reliability of its software on equipment that is not furnished by Hewlett-Packard. This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or translated to another language without the prior written consent of Hewlett-Packard Company. Intel and Pentium are registered trademarks of Intel Corporation. Microsoft , Windows NT , Windows 95 , and Windows 2000 are registered trademarks of Microsoft in the U.S. and other countries. Torx is a registered trademark of CamCar/Textron, Incorporated. HP Tower Server tc3100 Installation Sheet Setting Up the HP Server tc3100 Audience Assumptions This guide is for the person who installs, administers, and troubleshoots LAN servers. Hewlett-Packard Company assumes you are qualified in the servicing of computer equipment and trained in recognizing hazards in products with hazardous energy levels. The instructions in this document are provided in greater detail in the HP Server tc 3100 Operations and Maintenance Guide. Configuring the HP Server 1. Power on the HP Server and the monitor: u Insert the HP Server Navigator CD-ROM in the CD-ROM drive. u The server should boot from the HP Server Navigator CD on its own; if not, turn the power off, wait 10 seconds and turn the power back on again. u If the system fails to boot, follow the instructions on the screen. u Press F2 to enter setup, or u Press F4 to accept automatic configuration update (if prompted to do so). 2. Configure the HP Server and Install the Network Operating System (NOS): u During the configuration process you will be asked to select the NOS Installation Mode. u From the HP Server Navigation Main Menu, view the system Readme from the HP Navigator main menu for the most current installation information. u Use the HP Server Navigator to configure the server. If you use Navigator's Guided, Custom, or Replication modes, you will be prompted through the process. NOTE) If certain versions of the Microsoft Windows NT Server are used, a prompt will appear indicating selections of automated or manual NOS installation. u) Choose the automated NOS installation mode for first-time installations of Microsoft Windows 2000 (NT) Server on the factory-configured HP Server. You will be guided through the process by a series of HP display screens.) u) Perform a manual install if you are installing a NOS other than Microsoft Windows 2000 (NT) Server or if you have replaced HP components (for example, adding a SCSI controller board from a third-party). You will need to use the NOS vendor's installation process. Before you leave the Navigator and install your NOS, be sure you view and print the HP-customized NOS installation instructions and create the driver diskette(s) for the NOS you are installing. ) )) 3. Install or Configure Tape Backup Software: u) If your HP Server uses a tape backup device, install and/or configure the tape backup software now. Refer to the Tape Backup Getting Started Guide for instructions on installing and configuring the tape backup software. 4. Refer to the HP Server Online Documentation CD-ROM: u) Use this CD-ROM for updated information about your HP Server and as a reference for any additional information not provided in this Installation Sheet. 5. Run DiagTools (Optional): u) Create the HP DiagTools diskettes from the HP Server Utilities (or Diskette Library) on the HP Server Navigator CD-ROM. ) u) Run HP DiagTools and after completing all the configuration topics, save the support ticket to a diskette for future reference.