HP StorageWorks 1500cs HP StorageWorks 1500 Modular Smart Array Installation G - Page 95
Tru64 UNIX environments, The AlphaServer must have Tru64 UNIX v5.1.b PK4 or later installed.
View all HP StorageWorks 1500cs manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Configuration Procedures - Other Environments d. For each HBA, verify that the following options are specified: load ql2x00.ham slot=x/luns/allpaths/portnames, where x represents the slot number. Note: The Native MPIO solution can co-exist with HP Secure Path for NetWare. ■ If the MSA is upgraded to 6.86or later active/active firmware, and, if you want to remove the Secure Path for NetWare driver, do the following: a. Follow the removal instructions provided in the Secure Path user documents. b. From the console, enter edit c:\NWSERVER\STARTUP.NCF. c. Comment out the following entry: #load hpqsp.cdm d. Enter edit sys:\system\autoexec.ncf e. Comment out the following entries: LOAD hpqspagt.nlm LOAD hpqspahw.nlm Tru64 UNIX environments ■ Single-controller configurations and active/passive firmware are not supported; the MSA must be upgraded to dual-controllers running active/active firmware. ■ The AlphaServer must have Tru64 UNIX v5.1.b PK4 (or later) installed. ■ The AlphaServer must be configured in a SAN switch zone with the MSA. ■ After installing the MSA, be sure to set the host mode for each Tru64 UNIX connection to tru64. ■ For information on upgrading the MSA to active/active, see the migration instructions for Tru64 UNIX environments, available on the Technical documents page of the MSA1500 website: http://www.hp.com/go/msa1500cs. HP StorageWorks 1500 Modular Smart Array Installation Guide 95