HP StorageWorks 1606 HP StorageWorks 8GB SAN Switch hardware reference guide ( - Page 26
SAN Switch ISL Trunking groups
View all HP StorageWorks 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
4. Install the license: a. Log in to the switch as admin. b. Issue the licenseadd command, followed by the license key enclosed in quotation marks. (The license key consists of approximately 16 uppercase and lowercase letters and numerals.) IMPORTANT: Enter the license key exactly as issued. If you enter the key incorrectly, the license will not function properly. c. Enter the licenseshow command to verify that the license is valid. If a licensed product is not displayed, the license is not valid. NOTE: It is not necessary to reboot the system. 5. Configure the inactive ports. Enter the portstart command to start the ports. This command loads the port code, unlike the portenable command, which enables the port laser. For example: portstart 16-31 6. Enter the portenable command to enable the ports. For example: portenable 16-31 7. Optional: Enter the portshow command to verify that the newly activated ports are started. SAN Switch ISL Trunking groups All 8-Gb SAN Switch models support ISL Trunking as an optional, licensed feature for FC ports. When this feature is enabled, trunked groups of up to eight contiguous ports are created. For example, the Fibre Channel ports on the SAN Switch are numbered from left to right and color-coded into groups of eight to indicate which ports you can combine into trunked groups. Figure 12 shows the 8/8 SAN Switch with three trunked groups of eight ports. NOTE: If your 8-Gb SAN Switch is licensed for ISL Trunking (for example, Power Pack+ models ship with this license), use the trunking groups available on the switch. 26 HP StorageWorks 8-Gb SAN Switches