HP StorageWorks 2/128 HP StorageWorks Fabric OS 5.3.1b release notes (5697-764 - Page 21
Incorrect GID_FT response from NameServer. NameServer assumes
View all HP StorageWorks 2/128 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Closed defect summary Solution When upgrading 4/256 to Fabric OS 5.2.0b from 5.2.0a, both ISL trunk connections to an edge switch connected to FC4-16IP were lost. Found in test lab and due to "lab mode" setting, not accessible to customers. Fixed in Fabric OS 5.3.0 Counter Address_err counting inappropriate data. Fixed in Fabric OS 5.3.0 When assigning IP address to a GE port with no cable connection, the FC4-16IP Blade incorrectly reports back to iSCSI initiator that port is valid. Fixed in Fabric OS 5.3.0 The 4/8 and 4/16 SAN Switches would display "Fan x is not faulty" messages on boot up after upgrade to Fabric OS 5.2.0x, even Fixed in Fabric OS 5.3.0 though fans were ok. Disconnecting Rx end of cable on an L_Port and leaving the Tx end unchanged results in unexpected behavior. Fixed in Fabric OS 5.3.0 Access Gateway should handle an IPv6 address in a GMAL payload IP address in "ag - show" truncated to 16 characters (size of IPv4 address) depending on size of IP address string for edge switch to which N_Port attached. Fixed in Fabric OS 5.3.0 Switchdisable and switchenable on switch that directly connects to storage will cause the storage to see GLIEN reject error message. Fixed in Fabric OS 5.3.0 F_Port count is incorrect in agshow on the 4/32 SAN switch. Fixed in Fabric OS 5.3.0 In CLI, iscsicfg -show/delete ddset -n xxx complains "requested object does not exist" even though it does exist, due to DD/DDSETs received from Microsoft iSNS server being in uppercase. Fixed in Fabric OS 5.3.0 During iSCSI 1024 session stress testing, one port lost multiple sessions. Even though switchshow -iscsi showed less than 64 sessions, iSCSI initiator wasn't able to log in to the target (out of resources error). Fixed in Fabric OS 5.3.0 Incorrect GID_FT response from NameServer. NameServer assumes device's FC4 type is FCP when GID_FT request is sent to the switch asking for PIDs of type FCP. PID of the sending device is incorrectly included in the reply list. Fixed in Fabric OS 5.3.0 Unable to merge an upgraded switch with a 4/256 with FC4-48 Blade when using domain/port zoning of the upper 32 ports of the Blade. When creating D,P zoning definition using these upper 32 ports on FC4-48 connected to another switch running 5.1.0, the two switches correctly segment due to zoning conflict. After upgrading to 5.2.0, switches remain segmented, but segmentation should be removed. Fixed in Fabric OS 5.3.0 HP StorageWorks Fabric OS 5.3.1b release notes 21