HP StorageWorks 2/128 HP StorageWorks Fabric OS 5.3.x administrator guide (569 - Page 213
portCfgPersistentDisable, ipAddrSet, switchName, secModeEnable, fabricShow, configShow
View all HP StorageWorks 2/128 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 213 highlights
This procedure restores most configuration parameters to factory defaults. After performing this procedure, you must check the new configuration and reconfigure those parameters that you customized in the old configuration. NOTE: This procedure restores most configuration parameters to factory defaults. After performing this procedure, you must check the new configuration and reconfigure those parameters that you customized in the old configuration. During this procedure, power is reset and the CP blades are rebooted, so traffic on the fabric is disrupted. If the fabric is in secure mode, enabling security on the new domains is a complicated task. You should avoid converting existing SAN Director 2/128 models that are acting as the core in a core-edge network. To convert a SAN Director 2/128 to support two domains: 1. Connect to the switch and log in as admin. 2. If the Director is already in a fabric, minimize disruption by removing the Director from the fabric using one of the following methods: • Physically disconnect the Director. • Use the portCfgPersistentDisable command on all connected remote switches to persistently disable their ports that are connected to the Director, or remove ISLs that connect the SAN Director 2/128 to the current fabric. 3. Enter the chassisConfig command to change the configuration from the default (one domain) to two domains. This command reboots the system. switch:admin> chassisconfig 2 During the conversion, you are prompted to save the configuration of sw0. Follow the prompts to save the configuration file. 4. Enter the ipAddrSet command to set and confirm the IP address of sw1 (sw1 takes on a default that must be corrected). The IP address of sw0 will already be set. 5. After the system reboots, log in again as admin to each logical switch and enter the switchName command to assign a name to the new switch. 6. Using the configuration file saved in step 3 as a guide, manually reconfigure sw0 and sw1. Do not configure zoning parameters; these are propagated automatically when you merge the Director into the fabric. 7. If the fabric is in secure mode, perform the following steps; otherwise, proceed to step 8. a. Optionally, to configure sw0 and sw1 in one operation, connect them with an ISL link to form a temporary fabric. b. If you want sw0 and sw1 to be fabric configuration servers, update the overall fabric's FCS policy to include them. If not, skip this step. c. On sw0, enable security mode and use the secModeEnable command to create an FCS list that matches your overall fabric's FCS policy. d. Reset the version stamp on sw0. e. If you connected sw0 and sw1 in step a and you do not want them connected, disconnect the ISL link between them. If you did not connect them, repeat step 7b through step 7d on sw1. 8. If you physically disconnected the switch in step 2, reconnect it to the fabric. 9. If you used the portCfgPersistentDisable command in step 2, use the portCfgPersistentEnable command to persistently enable all ports that connect the switch to other switches in the fabric. 10. Enter the fabricShow command to verify that sw0 and sw1 have been merged with the fabric. 11. Enter the configShow command to verify that zoning parameters were propagated. Fabric OS 5.3.0 administrator guide 215