HP StorageWorks 2300 Disk System/Configuration Specific Instructions - Page 8

Step 1, Step 2, Step 3, Step 4, Step 5, Step 6, Step 7, Procedure Completed

Get HP StorageWorks 2300 - Disk System PDF manuals and user guides View all HP StorageWorks 2300 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

NT Follow these instructions for NT systems. Physically replace the disk. Note The procedure is detailed below in the Disk Replacement Procedure section, as well as on the Disk Replacement Sheet provided with the replacement drive. Step 1 After installing the disk module, execute the Disk Administrator utility to configure the new disk module. Step 2 To execute select Start -> Programs -> Administrative Tools -> Disk Administrator. Step 3 The new drive detection wizard will detect the new devices and will write a signature to each device. Choose yes at the prompts questioning these actions. Step 4 From the list of drives, choose the first unconfigured drive by right clicking on the free space. Choose create to create a new volume, then choose to use the entire available disk space. Step 5 Then right-click on the unformatted volumes and select commit changes now and press OK to the update emergency repair disk notice. Step 6 Right-click once again and choose format. Select to format using NTFS and give the volume a name. Choose quick format and press OK to continue. Step 7 Once formatted, repeat the process for each of the remaining drives. At this point, the system should be fully functioning. Procedure Completed! Congratulations! 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
8
NT
Follow these instructions for NT systems.
Physically replace the disk.
Note
The procedure is detailed below in the Disk Replacement Procedure
section, as well as on the
Disk
Replacement Sheet
provided with the replacement drive.
Step 1
After installing the disk module, execute the Disk Administrator utility to
configure the new disk module.
Step 2
To execute select Start -> Programs -> Administrative Tools -> Disk
Administrator.
Step 3
The new drive detection wizard will detect the new devices and will write a
signature to each device.
Choose yes at the prompts questioning these actions.
Step 4
From the list of drives, choose the first unconfigured drive by right clicking
on the free space.
Choose create to create a new volume, then choose to use the entire available disk
space.
Step 5
Then right-click on the unformatted volumes and select commit changes now
and press OK to the update emergency repair disk notice.
Step 6
Right-click once again and choose format.
Select to format using NTFS and give the volume a name.
Choose quick format and press OK to continue.
Step 7
Once formatted, repeat the process for each of the remaining drives.
At this point, the system should be fully functioning.
Procedure Completed!
Congratulations!