HP StorageWorks 3800ux HP StorageWorks 30ux Standalone UDO Drive Setup Guide ( - Page 29

Configuration Connection to Windows 2000 and 2003 Server versions (32- and 64-bit systems) Caution: To avoid software conflicts due to RSM drivers claiming the device, do not attempt to attach a standalone UDO drive to a Windows system before completing the following steps. The Windows operating systems do not offer any native driver support for file systems (NTFS) for the 8K sector sized UDO media. Though native support is not offered by the Windows operating systems, there are important steps required in order for your device to operate correctly, including after third party software has been installed. 1. Disable Removable Storage Manager and reboot the system before attaching the standalone UDO drive. 2. Windows 2000 systems require a minimum of Service Pack 4 to be installed as well as Microsoft Hotfix, as described in Knowledge Base Article KB831293. This patch is required for the Windows operating system to recognize an 8K sector sized device. Note: If you are using a supported software application, the UDF driver for the Windows file system is not required. Connection to HP-UX (11.x) The following procedures are for configuring an HP-UX operating system to use native drivers with the standalone UDO drive. Obtaining HP-UX patches Your HP-UX system may require software patches to ensure that the standalone UDO drive will install and operate correctly with your system. HP-UX versions 11.0, 11.11 and 11.23 require patches. To view the most up-to-date list of patch requirements, visit http://www.hp.com/go/udo. To download required patches, go to http://www.hp.com/go/support or refer to your HP-UX documentation for patch locations. HP StorageWorks 30ux Standalone UDO Drive Setup Guide 29