HP StorageWorks 4/256 Brocade Fabric OS MIB Reference (53-1000241-01, November - Page 26
SilkWorm 7500 / FR4-18i and Brocade MIBs, Firmware Upgrades and Enabled Traps, Fabric OS Commands
View all HP StorageWorks 4/256 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
1 SilkWorm 7500 / FR4-18i and Brocade MIBs SilkWorm 7500 / FR4-18i and Brocade MIBs EX_Ports, VEX_Ports, or VE_Ports display as "other" through SNMP. There are no statistics available from VE_Ports. Information about the GbE port type is not supported. The changes in the sensor details for FR4-18i Blade has been incorporated into SNMP. The "connUnitSensorTable 1.3.6.1.3.94.1.8" on page 8-16 and "swSensorTable 1.3.6.1.4.1.1588.2.1.1.1.1.22" on page 5-24 display information consistent with the Fabric OS sensorShow command. Firmware Upgrades and Enabled Traps Prior to Fabric OS v4.4, traps were turned on and off as a group (for example, the SW-Trap, or FATrap). In these versions of the Fabric OS it was not possible to set individual traps (such as, swSensorStatusChangeTrap, swTrackChangesTrap, or connUnitEventTrap). In Fabric OS v4.4 or above you can to turn on and off traps individually within a trap group. After the trap group is enabled, the individual traps need to be enabled explicitly. Because the pre- Fabric OS v4.4 firmware only has trap group level settings, when you upgrade to the Fabric OS v4.4 firmware or above, individual traps are turned off by default even if the corresponding trap group was enabled before upgrading. When moving from a downlevel version to Fabric OS v4.4 or above you must use either snmpmibcapset or snmpconfig command to turn on explicitly the individual traps within each trap group. Fabric OS Commands for Configuring SNMP Use the following commands to configure MIBs in the Fabric OS. See the Fabric OS Administrator's Guide for on procedures on configuring SNMP on the SilkWorm switches. Table 1-7 Commands for Configuring SNMP Command Description snmpConfig Introduced in Fabric OS v4.4.0, this command has all the features of the existing the agtcfg* commands; in addition, it has SNMPv3 configuration parameters. snmpMibCapSet Enhanced in Fabric OS v4.4 to provide a filter facility at the trap level (previously the filter facility was at MIB level for traps). 1-8 Fabric OS MIB Reference Publication Number: 53-1000241-01