HP StorageWorks 4/64 Brocade Converged Enhanced Ethernet Administrator's Guide - Page 88
Restricting the port from becoming a root port, Restricting the topology change notification
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
5 Configuring STP, RSTP, or MSTP on CEE interface ports To specify the port priority on the CEE interface, perform the following steps from Privileged EXEC mode. 1. Enter the configure terminal command to enter global configuration mode. 2. Enter the interface command to specify the CEE interface type and slot/port number. switch(config)#interface tengigabitethernet 0/1 3. Enter the no shutdown command to enable the CEE interface. 4. Enter the spanning-tree command to specify the port priority on the CEE interface. switch(conf-if-te-0/1)#spanning-tree priority 32 Restricting the port from becoming a root port From the CEE interface, use this command to restrict a port from becoming a root port. The default is to allow the CEE interface to become a root port. To restrict the CEE interface from becoming a root port, perform the following steps from Privileged EXEC mode. 1. Enter the configure terminal command to enter global configuration mode. 2. Enter the interface command to specify the CEE interface type and slot/port number. switch(config)#interface tengigabitethernet 0/1 3. Enter the no shutdown command to enable the CEE interface. 4. Enter the spanning-tree command to restrict the CEE interface from becoming a root port. switch(conf-if-te-0/1)#spanning-tree restricted-role Restricting the topology change notification From the CEE interface, use this command to restrict the topology change notification BPDUs sent on the interface. By default, the restriction is disabled. To restrict the topology change notification BPDUs sent on the CEE interface, perform the following steps from Privileged EXEC mode. 1. Enter the configure terminal command to enter global configuration mode. 2. Enter the interface command to specify the CEE interface type and slot/port number. switch(config)#interface tengigabitethernet 0/1 3. Enter the no shutdown command to enable the CEE interface. 4. Enter the spanning-tree command to restrict the topology change notification BPDUs sent on the CEE interface. switch(conf-if-te-0/1)#spanning-tree restricted-tcn Enabling spanning tree From the CEE interface, use this command to enable spanning tree on the CEE interface. By default, spanning tree is disabled. 68 Converged Enhanced Ethernet Administrator's Guide 53-1001346-01