HP StorageWorks 4/64 HP StorageWorks Fabric OS 6.1.0c release notes (5697-7680 - Page 19
Fabric OS 6.1.0a
View all HP StorageWorks 4/64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Fabric OS 6.1.0a fixes Table 7 lists defects closed in the Fabric OS 6.1.0a firmware release. Table 7 Fabric OS 6.1.0a closed defects Closed defect summary Solution Under rare conditions, fabric mode TopTalker monitor does not display correct flow values. Fixed in Fabric OS 6.1.0a Attempting to configure port mirroring on a director with both 4Gb and 8Gb blades may result in a software Verify error. Fixed in Fabric OS 6.1.0a After repeatedly running bladedisable/enable on one FC8-48 blade for six hours, a DC Director panics. Fixed in Fabric OS 6.1.0a FCR matrix settings may not persist after hafailover on a 4/256 SAN Director. Fixed in Fabric OS 6.1.0a When disabling/enabling a port, Port Fencing disables the port because the allowable number of invalid transmission words is exceeded. Fixed in Fabric OS 6.1.0a Under rare conditions, a DC Director panics during SAK IRNDUP when the software watchdog detects an unexpected termination of the FICON CUP daemon (ficud). Fixed in Fabric OS 6.1.0a Port Based Routing with DLS ON does not immediately balance the load when adding an ISL. Fixed in Fabric OS 6.1.0a Ex_Port fails to come online after downgrading firmware from Fabric OS 6.x to 5.3 under certain conditions. Fixed in Fabric OS 6.1.0a Fastwrite performance issue with a particular FCIP ex-port configuration. Fixed in Fabric OS 6.1.0a During storage failover/failback test with IP over FC, traffic stops and fails to recover in single and dual backbone configurations. Fixed in Fabric OS 6.1.0a During non-disruptive firmwaredownload, Ex_Ports may toggle, causing traffic disruption in a 8/40 SAN Switch and 8/80 SAN Switch. Fixed in Fabric OS 6.1.0a After hareboot, "Probing failed" on F_Port messages may be seen on the 8/8 SAN Switch, 8/24 SAN Switch, 8/40 SAN Switch or 8/80 SAN Switch. Fixed in Fabric OS 6.1.0a Under rare conditions, ISL may get stuck at G_Port on the 8/8 SAN Switch, 8/24 SAN Switch or 8/80 SAN Switch. Fixed in Fabric OS 6.1.0a Launching Switch Throughput graph in Advanced Performance Monitor for the 8/8 SAN Switch, 8/24 SAN Switch, 8/40 SAN Switch or 8/80 SAN Switch. Throughput graph will not display 8G/sec values. Fixed in Fabric OS 6.1.0a On a 8/80 SAN Switch, the system status LED does not flash amber/green when a power supply is faulted. The system status LED remains steady green. Fixed in Fabric OS 6.1.0a HP StorageWorks Fabric OS 6.1.0c release notes 19